EvErything you want to know about thE v2 autogEn controllEr. V2 AutoGen controllers are the new milestone created in the field of Automatic Start Generator Controllers. It is the next level of generator controller that utilizes sophisticated flow loop algorithm to perform demand base control on petrol or diesel generators. V2 AutoGen is a fully automated generator controller that monitors battery bank voltage in off grid scenarios, utility power presence,remote management and much more. It comes with wireless connectivity to the internet. Through the AutoGen mobile app, you have full control of manual starting and stopping of your generator, view parameters such as battery bank voltage, generator running status, error notifications and more. Its installation process is simple. V2 AutoGen is the smart Automatic Start Generator Controller that can fit any electric start diesel or petrol generator. It can be utilized for other applications such as petrol engine water pumps, marine generators, engine driven compressors, etc. We can customize the controller to suit your needs. By installing AutoGen smart Automatic Start Generator Controller to your generator, you give the engine a brain. A microprocessor controls its automatic start and stop function. Combined with the mobile app through Wi-Fi connectivity displaying battery voltage, Auto Start Backup Generator generator running status, and you also have an option of the manual start or stop of the generator from any location around the world. If an error occurs during the process, then the error notification will be sent to you through an email. It will take three start attempts. Suppose your generator is unable to start due to low fuel, mechanical failure or anything else, Automatic Generator Controller it will enter into an error state. In that case, V2 AutoGen controller will notify you with an email to correct the malfunction. It monitors battery voltage and starts your generator automatically to charge them. When batteries have reached 100% charge state, it will shut off automatically. This feature makes it the perfect backup system for off-grid, wind, solar, boat, telecommunication or caravans etc. In general, most small scale generators are equipped with choke lever. In this case, the choke lever must be engaged for the generator to initiate a correct fire up. With the addition of the choke servo, the process will be automatic with V2 AutoGen controller. Its installation process is simple, fix the servo close to the carburettor and customize the linkage to activate choke butterfly, with Plug-and-play fitting to connect with V2 AutoGen controller. If you want to use your V2 AutoGen controller remotely, connect to your home or site’s Wi-Fi access point. Note that there is also an external antenna to extend it up to 50 meters range. The current sensor module is designed to measure the charging current or load current to and from the battery bank. The maximum current reading is 200 amps DC. With the presence of the current sensor module in the system, you will be able to view the current measurement in-app present on your phone. Its installation is easy by fitting the split core current sensor module around a positive cable of the battery bank in line with charger or inverter, and you are good to go.